///MZ3.Net
  Main
  Search
  Pictures
  Article Index

Care & Maintenance
  Cleaning
  Maintenance
  Squeaks & Rattles

Upgrades
  Stereo
  Handling
  Performance
  Convenience
  Safety/Security
  Visual-Exterior
  Visual-Interior
  Other/Misc
Article Breakdown
  • Rear Turn Signals
  • Side Markers
  • Front Bumper Lamps
  • Clear Rear Turn Signals, Side Markers and Front Bumper Lamps
    April 11, 1998
    By: Alan Riley
    Pros:Neat looking upgrade without much cost or effort
    Cons:Not sure if this is officially street lega
    Cost:$17.90 (list each)

    BMW part numbers: 63-13-2-493-613 (left), 63-13-2-493-614 (right)
    Push the side marker lamp towards the rear of the car. Pull out on the front of the lamp after you slide it towards the rear. It should come out without too much effort.

    Once the side marker lamp is off of the car, it is easy to disconnect the wire to it. You will need to pull up slightly with your fingernail on a little clip on the connector for it to come apart easily. Be careful at this point not to drop the wire through the hole in the side of your car.

    Attach the wire to the new clear side marker lamp and install the lamp in the hole in the side of your car. Start by placing the rear of the lamp in the hole first, pushing towards the rear of the car. Then, push the front of the lamp into the hole and push the whole lamp towards the front of the car to secure it. Check the rubber seal around the lamp at this point to make sure it isn't folded or crimped under the lamp.

    Replacing the front bumper marker lenses

    Copyright © 1997-2003 by Robert Leidy and ///MZ3.Net. All rights reserved. This material is for individual use only and may not be copied, republished or redistributed without the prior written consent of ///MZ3.Net. ///MZ3.Net shall not be liable for any errors, inaccuracies, omissions or other defects in the information on ///MZ3.Net, or for any claims or losses arising therefrom.